Regular maintenance process of paper cup machine

1. Deep cleaning of paper cup machine
In addition to daily cleaning, deep cleaning is also required regularly, including disassembling some detachable parts for thorough cleaning, and cleaning dust and dirt in hard-to-reach corners and crevices. This helps reduce equipment failure rate and improve production efficiency and product quality.

2. Inspection of electrical system of paper cup machine
The electrical system is the nerve center of paper cup machine. Regularly check the working status of electrical circuits, controllers, sensors and other components to ensure accurate signal transmission and sensitive and reliable control action. At the same time, pay attention to moisture and dust prevention to avoid damage to electrical components due to harsh environment.

3. Adjustment and replacement of mechanical parts of paper cup machine
According to the use of equipment, mechanical parts are adjusted and replaced regularly. For example, adjust the gap of the forming mold to ensure the quality of paper cup forming; replace the conveyor belt and hot pressing plate with severe wear to ensure stable production efficiency and product quality.

Common troubleshooting of paper cup machine
1. Poor forming of paper cup machine
The causes may include mold wear, poor paper feeding or insufficient hot pressing temperature. When handling, you can first check and adjust the mold gap to ensure smooth paper feeding; secondly, check and adjust the hot pressing temperature and time to ensure that the bottom of the paper cup is firmly bonded.

2. Abnormal noise of paper cup machine
Abnormal noise is usually caused by loose parts, wear or poor lubrication. When handling, you should carefully check the source of the abnormal noise, tighten loose parts, replace worn parts, and strengthen lubrication and maintenance.

3. Electrical failure of paper cup machine
Electrical failure may manifest as control failure, abnormal signal, etc. When handling, you should first check whether the power supply is normal, and then check the electrical components and circuits one by one to find the fault point and repair it.